Plastic spraying exhaust treatment

As the adhesion of plastic powder is relatively strong, the use of an increasingly wide range of plastic spraying is mainly polyester powder, acrylic powder, etc., in the spraying of plastic need to collect these powders and exhaust treatment, on the one hand, can be recycled, on the other hand, is the environmental requirements for the spraying of plastic exhaust treatment, which should be taken for the treatment of the management measures? The following with the Everest blue editor to take a look~

For the plastic powder recycling of plastic spraying, the general use of equipment is a vertical dust cabinet, also known as vertical vacuum cabinet, the plastic powder attached to the polyester fibre cartridge on the side, filtered by the cartridge, the clean air from the tail exhaust system.

For plastic spraying and drying of exhaust gas, there is not very thick smoke and breath, these gases are usually become organic waste gas, for the treatment of this exhaust gas can be a variety of exhaust gas treatment equipment for you to choose from, such as activated carbon adsorption equipment, photocatalytic exhaust gas purification equipment, low-temperature plasma equipment, cyclone spraying purification towers, etc., for the plastic spraying of exhaust gas throughout the process, need to be based on the site conditions Design of exhaust gas collection system, suction and exhaust system, exhaust system and other supporting systems, the collection of exhaust gas through the exhaust pipe into the exhaust trunk and then into the activated carbon adsorption equipment, activated carbon through the physical and chemical adsorption to remove organic pollutants in the exhaust gas, by purifying the non-polluting exhaust gas from the fan to the exhaust chimneys, and discharged through the 15-metre chimney outdoor.

If the emission requirements are more stringent, then the use of a device may not be fully processed, it is necessary to use a variety of equipment combined to deal with, such as the use of dry filtration + activated carbon adsorption + catalytic combustion process for treatment.

Plastic spraying exhaust treatment is introduced here, if you still do not understand, or need to do a detailed programme, the required equipment, such as quotations and other information, you can contact us (15322851710 Cen) consulting to obtain Oh.